The pulsar wizard pipe is a 510 vape battery shaped like a classic pipe. It hides your oil cart inside the bowl chamber, uses an internal battery, and gives you direct voltage control through a screen on the bowl.
Key details to keep in mind:
- The battery has a 650 mAh capacity and charges with a Type-C cable.
- You get two stems: a long stem for cooler vapor and a short stem for travel.
- The screen shows voltage output, battery life, and total puff count.
- The auto-draw sensor only works when a stem is screwed into place.
What the Pulsar Wizard Pipe is
This device is a 510-threaded cart battery built inside a fantasy pipe body. Instead of leaving the glass cartridge exposed on top of a slim stick, the cart screws directly into the recessed base inside the bowl.
The housing accommodates standard 0.5ml, 1ml, and most 2ml carts. The exterior shell covers the glass completely, which protects the tank if dropped. Two different stem covers come in the box: a short mouthpiece for easier pocket carry, and an elongated stem that lets vapor travel further before reaching your mouth.
If you need new carts for your setup, our cannabis delivery menu carries New York adult-use brands for local drop-off or pickup.
Hardware and Specifications
The pipe runs on a rechargeable 650 mAh cell that holds enough charge for multiple days of light sessions. For more background on how compact lithium cells operate, see the basic overview on Wikipedia.
A Type-C port sits near the base for recharging. The screen built into the top of the bowl displays real-time battery percentage, selected voltage, and an active draw counter. The device includes a preheat function that pushes 1.8V for eight seconds to soften cold oil and loosen clogs.
Loading a Cartridge
- Unscrew the stem from the pipe base to open the internal chamber.
- Screw your 510 cart into the gold connection port at the bottom of the well until it sits finger-tight. Avoid cranking it down too hard, which can pinch the bottom gasket.
- Slide your stem of choice down over the cart and thread it back onto the base until it stops.
The outer body acts as a dust shield, keeping pocket lint off the cartridge tip while you travel.
Controls and Screen Functions
The circular screen turns on when you take a puff, connect a charger, or press the primary button.
Powering on and off
Press the button five times in quick succession to turn the device on. Repeat the five clicks to shut it down.
Adjusting Voltage
Click the button twice to enter voltage select mode. The screen cycles from 1.8V up to 4.2V in single increments. Click until you hit your preferred setting.
Running Preheat Mode
If the cart is clogged, double-click the button while the device is in standby. A flame icon appears on the screen, and the battery fires at 1.8V for eight seconds.
Resetting the Puff Counter
The screen tracks your total hit count. To clear this number back to 0000, click the button three times fast and keep holding it down on the third click until the numbers reset. Resetting the count when you install a new 1ml cart lets you see your average usage across the 200 to 300 puffs a cart typically yields.
Airflow Mechanics and Stem Setup
The pipe gives you two different draw feels depending on the stem you choose. The long stem extends the vapor pathway, allowing heat to drop before you inhale. The short stem shortens the airway, creating a warmer hit and a smaller profile.
Both stems seal against a rubber ring inside the base. This seal is necessary for the auto-draw switch to detect incoming air. If you run the battery without a stem screwed on, the auto-draw switch will not trigger. You can still fire the device without a stem by holding the screen button down manually.
Voltage Guide by Extract Type
Different extracts require different heat levels to preserve flavor and avoid burning. You can review safety and testing standards for regulated oil products through the New York State Office of Cannabis Management.
- Live resin and live rosin (1.8V to 2.4V): Lower voltages protect volatile terpenes from burning, keeping the original plant flavor intact.
- Distillate carts (2.6V to 3.2V): Standard distillate is thicker and benefits from moderate heat to vaporize cleanly.
- High-viscosity oils (3.4V to 4.0V): Thicker oils require more power for dense vapor. Keep puffs brief at higher voltages to keep the internal ceramic coil saturated. Hardware safety details can be found via the U.S. Food and Drug Administration.
Starting new carts around 2.0V lets you test the draw before adjusting the voltage upward.
Cleaning and Maintenance
Clean the device every couple of weeks to prevent sticky oil from blocking electrical contacts:
- Wet a cotton swab with isopropyl alcohol and clean the gold 510 threads in the well.
- Push a soft pipe cleaner through the stem to clear out condensed oil residue.
- Keep moisture and excess alcohol away from the screen and charging port.
- Disconnect the Type-C cable once the display shows 100%.
If a cartridge ever leaks into the base, wipe it down immediately so oil does not enter the draw-activation port.
Frequently Asked Questions
Why does my pulsar wizard pipe only fire when I hold the button?
The draw sensor relies on the airtight seal created by the stem. Screw the stem on completely. If the stem is off, the auto-draw bypasses and you must use the button.
How long does the battery last between charges?
The 650 mAh cell generally lasts two to three days under moderate use.
Do all 510 cartridges fit in the chamber?
Standard 0.5ml, 1ml, and most 2ml carts fit without issue. Extra-wide specialty carts may be too wide for the stem cover to slide over.
What should I do if a cart gets clogged?
Trigger the preheat cycle by double-clicking the button. Draw gently through the mouthpiece while the flame icon shows on screen to clear the airway.
Looking for 510 carts in Fishkill?
Stop by our shop on Route 52 or reach out online to see what carts are in stock.
Contact Fishkill Cannabis
Compliance & Regulatory Notice
Warning: Cannabis has intoxicating effects and may be habit-forming. For use only by adults 21 years of age and older. Keep out of reach of children and pets. Cannabis can impair concentration, coordination, and judgment. Do not operate a vehicle or machinery under the influence of cannabis. Cannabis products sold in New York State are intended for consumption within New York State. Do not cross state lines with cannabis products.
FDA Disclaimer: These statements have not been evaluated by the Food and Drug Administration. This product is not intended to diagnose, treat, cure, or prevent any disease.